Dd-wrt Professional Activation Crackl EXCLUSIVE

This is the easiest way to get up and running using hard drive. 1. Connect the hard drive that will be used for dd-wrt to a windows machine either with usb or internal.2. Put both physdiskwrite and dd-wrt image file in drive c: or whatever your main drive is.3. Click Start and then Run, type "command" in the open box and click open to bring up a command prompt.4. At command prompt navigate to where physdiskwrite is located. "cd.." will go to next higher directory. Use command "dir" to list directory contents and verify that both files are there.5. type "physdiskwrite -u dd-wrt.image" dd-wrt.image is the actual name of the image file so replace it with what you downloaded from dd-wrt.com. The -u tag is used for large drives.6. BE VERY CAREFUL WITH NEXT STEP!!!!!!!! Next you will select drive to apply the image to. This will overwrite all contents on drive!! ususally your main drive is drive "0" and if you do not have another drive other than the dd-wrt drive then it should be drive "1". 7. Install drive into dd-wrt machine, connect NIC to another computer or to LAN. 8. Boot dd-wrt computer and after it says that eth0 is up then use other computer to configure remotely. Default ip is 192.168.1.1 so make sure you set your computer to the same subnet i.e 192.168.1.5. Open browser and type 192.168.1.1 into the location bar and the control panel for dd-wrt x86 should come up.9. If this is a registered install then you will then take the System Key displayed and enter it into the activations center at dd-wrt.com. 2b1af7f3a8